What are the technical requirements for installing aluminum veneer

After purchasing aluminum veneer, how to install it? As a manufacturer of aluminum veneer in Weifang, let me take you to understand the technical requirements for aluminum veneer installation together!

When installing the aluminum veneer, first connect the hanger pre installed on the triangular keel with the triangular keel and light steel keel vertically according to the plate spacing, then adjust the level to press the two sides of the square plate parallel into the triangular keel seam, first install the aluminum veneer, then find the right angle at both ends in the horizontal direction, and then pull a straight line to gradually buckle the plates into a row. After each row is buckled, adjust it once to ensure that the board surface is flat and the aluminum veneer joints are vertical. Hang the suspension rod and light steel keel at appropriate intervals. The spacing between aluminum veneer suspension rods is 1.2m, and the spacing between light steel support beams is 1.2m. When installing aluminum decorative buckle plates at the same horizontal height, gloves should be worn. If you accidentally leave stains on the board, clean it with clean water. It is strictly prohibited to remove the protective film when installing aluminum veneer. After installation, the protective film can be removed, but in rare cases, it may still be retained. However, removing the protective film can facilitate the cleaning and aesthetics of the exterior wall for the first time.